HOTSHOT DROP SPREADER MODEL #38185 38185 OWNER’S MANUAL
ASSEMBLY INSTRUCTIONS 1. Remove the spreader and components from carton and place hopper facing on a padded surface as shown. Insert lower ends of the handle brace inside the hopper, align the holes and attach the leg bracket using (2) 1/420 x 1 1/2” Hex bolts and Wing Nuts. Secure Leg to Bracket (Leg can be located in 2 positions to best fit operator) using (2) 1/4-20 X 1/2” Hex Head Bolts, and Wing Nuts. Repeat on opposite side. 2.
OPERATION 1. Before filling hopper, make sure spreader is in the “OFF” position. Always fill spreader on walk or drive, not on the lawn. 2. Turn the rate control dial to the desired setting. If setting is not known, try different settings until desired results are achieved. 3. Always push spreader, do not pull. Start spreader 5. Apply two header strips at each endof area to be treated and then proceed lengthwise between the header strips.
PARTS LIST FOR MODEL #38185 10 9 12 8 11 10 13 7 14 6 5 15 4 3 16 2 PART OF OUR SERVICE IS PROVIDING REPLACEMENT PARTS. Parts may be obtained through your local distributor Be sure to give: 1 19 18 17 Meyer Products, Inc. 1. SPREADER MODEL NUMBER 2. SPREADER NAME 3. PART NUMBER 4. NAME OF PART AS SHOWN Key Description 18513 Euclid Ave IF YOUR LOCAL DISTRIBUTOR CANNOT SUPPLY PARTS, CONTACT: Part No. Key Cleveland, Ohio 44112 216-486-1313 www.meyerproducts.com Description Part No.
