User Manual

5.4
1. Unclip the radio trim
bezel and remove.
2.
Remove (4) Phillips
securing the factory
radio and disconnect
the wiring. (Figure A)
3.
Snap the filler bar onto
the equalizer housing
and slide the assembly
onto the bottom of
the radio housing.
(Figure B)
4.
Cut and remove all
mounting tabs on the
Radio Housing EXCEPT
tabs “D”. (Figure C)
Continue to kit
assembly, p. 5.6
Eagle Talon/Mitsubishi
Eclipse/Plymouth
Laser 1990-1994
1. Unclip the radio trim bezel and remove.
2. Remove (4) screws securing the factory radio and
disconnect the wiring. (Figure A)
3.
Snap the filler bar onto the equalizer housing
and slide the assembly onto the bottom of the
radio housing. (Figure B)
Note: The factory pocket may be used by omitting
this step and mounting the pocket under the Radio
Housing during installation.
4.
Cut and remove all mounting tabs on bracket Set
#1 EXCEPT tabs “H”.
5.
Mount the converted brackets to the back
of the assembly with (6) #8 x 3/4” hex-head
screws supplied. (Figure C)
Continue to kit assembly, p. 5.6
Mitsubishi Galant 1985-1988
Mitsubishi Sigma 1989-1990
Dash Disassembly 99-7000
(Figure A)
(Figure B)
(Figure A) (Figure B)
(Figure C)
“D”
“D”
Mounting tab(s): identified by a
stamped letter on back of tab
(Figure C)
Mounting tab(s): identified by a
stamped letter on back of tab
“H”