Datasheet

Specifications
CV-5200 Series
Connection Validation™ Soldering Station
Cartridge & Heater Series Legend
Cartridge Series
• CVC – Connection Validation Cartridges,
Connection Validation enabled
• SMC – Surface Mount Cartridges
• New cartridge series to be added soon
Heater Series – represented by the x in the part
number.
• 5-500 series heaters
• 6-600 series heaters
• 7-700 series heaters
• 8-800 series heaters
• 9-900 series heaters
BL Blade KN Knife
BV Bevel MH Mini-Hoof
CH Chisel QD Quad
CN Conical SC
Slotted
Cylindrical
CP Hollow Cup SH Shield
TN Tunnel SL Slot
HF Hoof WV Wave
HK Hook FB Flat Blade
HP Hot Plate VC V-Groove Chisel
HS Heat Stake PC Pin Connector
LG Long Groove SK Socket
Dimensions
Four digit numerical value, which represents the key dimension of the
geometry.
Special Designator
Provides an additional level of identification to the cartridge to better
identify any unique attributes
A Access additional length in one axis, >10mm
D Deep Taper
H High Mass Similar in design to another tip geometry
with increased thermal mass
J Reach with Taper additional length >10mm with a change in
axis, Taper
L Long Life increased tip plating
N Non-Wetting 1 or more surfaces that are non-wetting
P Power reduced length in one-axis, <6.5mm
Q Square Square end feature for Flat Blade
geometry
R Reach additional length >10mm with a change in
axis
S Standard
T Taper Taper with Step
U Round Round end feature for Flat Blade
geometry
V Concave
W Enlarged Wetting
Area
X
Power & Long Life reduced length in one-axis, <6.5mm,
increased tip plating
Geometry
New Cartridge Smart Numbering Scheme
With the introduction of
Connection Validation,
Metcal is migrating to a
new smart numbering
convention that is designed
to assist the operator or
the process engineer in the
selection of the correct
cartridge for the
application.
Note: STTC/SMTC cartridges will not work on CV-5200 series
systems.