Service manual

ATTENTION:

OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES

Removal/Installation of Major Assemblies -

EVO Wallette Ion

Bill Acceptor Removal

1. Turn off and unplug the game.

2. Unlock and open the cash door.

3. Remove the coin box and remove the bill acceptor magazine from the game.

4. Remove the screw securing the coupler bracket but keep the cable(s) connected. This bracket

only needs to be moved aside in order to access the screw underneath. See Figure 14.

5. Remove the 4 screws securing the bottom support piece to the game and remove the bottom

piece. If necessary, remove the nut and screw securing the meter bracket and remove the bracket

in order to access the screws. See Figure 14.

6. Remove the remaining screw securing the bill acceptor mounting clip to the game. See Figure 14.

7. Gently pull up on the bill acceptor so that you can access the two connectors on the right side. You

may need to use a flat-head screwdriver to pry underneath the metal mounting clips to free the bill

acceptor. Disconnect the 2 wire connectors from the bill acceptor, making sure to note the loca-

tion and orientation of each connector. Then, remove the bill acceptor from the game.

8. Remove the 2 screws securing the front of the bill acceptor to the mounting clip.

Bill Acceptor Installation

1. Reattach the bill acceptor mounting clip to the front of the bill acceptor with the 2 screws.

2. Reconnect the 2 wire connectors at the top and the bottom of the bill acceptor, with a gap left in

between. The 10-pin connector should be plugged in above the 12-pin connector. NOTE: The

connectors MUST be installed in the proper slots. Failure to do so will result in game

malfunction.

3. Replace the bill acceptor assembly in the game and secure the left side of the mounting clip with

the screw. See Figure 14. Do not reinstall the screw on the right side yet.

4. Replace the bottom support piece and secure it using the 4 screws. NOTE: If you are having

difficulty reinstalling the bottom piece, loosen the remaining screw securing the bill ac-

ceptor mounting clip to the game (See Figure 1). After installing the bottom piece, make

sure to re-tighten the screw.

5. Replace the bill acceptor magazine and the coin box.

6. Replace the coupler bracket, and secure it (and the right side of the bill acceptor mounting clip)

with the screw.

7. If you removed the meter bracket, replace it and secure it to the game with the screw and nut.

Troubleshooting Information - Removal/Installation of Major Assemblies -

EVO Wallette Ion

Megatouch Ion Technical Reference Manual

8. Close and lock the cash door.

9. Plug in and turn on the game.