Service manual

Power Supply Removal

1. Turn off and unplug the game.

2. Unlock and open the CPU section.

3. Unplug the IEC connector from the power supply. See Figure 9.

4. Disconnect the wire connector nearest to the power supply.

5. Remove the 2 screws fastening the power supply and mounting bracket to the game. See

Figure 10.

6. Remove the power supply.

Power Supply Installation

1. Install the new power supply and bracket in the game and fasten them with the 2 screws that

were used to fasten the old power supply and bracket. See Figure 10.

2. Connect the power supply wire connection.

3. Reconnect the IEC connector to the power supply. See Figure 9.

4. Close and lock the CPU section.

5. Plug in and turn on the game.

Troubleshooting Information - Removal/Installation of Major Assemblies -

EVO/EVO Wallette/Elite Edge Ion

Megatouch Ion Technical Reference Manual

ATTENTION:

OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES

Removal/Installation of Major Assemblies -

EVO/EVO Wallette/Elite Edge Ion