Operation Manual

Opening and closing the roller sun-
blinds
Overhead control panel
:
To open
;
To open
=
To close
You can only close the roller sunblinds when
the panorama roof with power tilt/sliding
panel is closed.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock (Y page 157).
X
Press the 3 switch in direction :.
Both roller sunblinds open, then the pano-
rama roof with power tilt/sliding panel is
raised.
X
Pull the 3 switch in direction ;.
The sunblinds open
X
Pull the 3 switch in direction =.
The roller sunblinds close when the pano-
rama roof with power tilt/sliding panel is
closed.
If you press or pull the 3 switch beyond
the point of resistance, automatic operation
is started in the corresponding direction. You
can stop automatic operation by pressing or
pulling again.
Resetting the panorama roof with
power tilt/sliding panel or the front
roller sunblind
Reset the panorama roof with power tilt/slid-
ing panel or the front roller sunblind if the
panorama roof with power tilt/sliding panel
or the roller sunblinds does not move
smoothly.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock (Y page 157).
X
Pull the 3 switch repeatedly to the point
of resistance in the direction of arrow :
until the panorama roof with power tilt/
sliding panel is fully closed.
X
Keep the 3 switch pulled for an addi-
tional second.
X
Pull the 3 switch in the direction of
arrow : repeatedly until the front roller
sunblind is closed.
X
Keep the 3 switch pulled for an addi-
tional second.
X
Make sure that the panorama roof with
power tilt/sliding panel (Y page 103) and
the front roller sunblind (Y page 105) can
be fully opened again.
X
If this is not the case, repeat the steps
above again.
Sliding sunroof
105
Opening and closing
Z