Owners Manual

Design Explanation
Day Mode
The display is set
permanently to day
design.
Night Mode
The display is set
permanently to night
design.
Automatic
The display design
changes depending on
the brightness around
the vehicle.
i
In the Automatic setting, COMAND
evaluates the readings from the automatic
vehicle light sensor and switches between
the display designs automatically.
Time settings
General information
If COMAND is equipped with a navigation
system and has GPS reception, COMAND
automatically
sets the time and date. You can
also adjust the time yourself in 30-minute
increments, but the date cannot be changed.
i
If you set the time in 30-minute
increments, any time zone settings and
settings for changing between summer and
standard time are lost (Y page 129).
i The following navigation system functions
require the time, time zone and summer/
standard time to be set correctly in order
to work properly:
R
route guidance on routes with time-
dependent traffic guidance
R
calculation of expected time of arrival
Setting the time
X
Select Vehicle
in the main function bar by
turning cVd the COMAND controller and
press W to confirm.
X
Select System by turning cVd the
COMAND controller and press W to
confirm.
X
Select Time by turning cVd the COMAND
controller and press W to confirm.
X
Select Time and press W to confirm.
:
Setting the time
;
Current date (set automatically by
COMAND)
X
Set the time by turning cVd
the COMAND
controller and press W to confirm.
Setting the time/date format
X
Select Vehicle
in the main function bar by
turning cVd the COMAND controller and
press W to confirm.
X
Select System by turning cVd the
COMAND controller and press W to
confirm.
X
Select Time by turning cVd the COMAND
controller and press W to confirm.
X
Select Format and press W to confirm.
The #
symbols show the current settings.
128
System settings
COMAND