User Manual

Connecting the Antenna to the Patient Programmer

1. Pull out the rubber plug on the patient programmer to reveal

the antenna connector.

Note: The antenna connector is located on the end of the

programmer near the keypad.

2. Insert the antenna’s metal plug into the antenna connector and

push the metal plug until it fits securely into place.

Disconnecting the Antenna

1. Grasp the plug and pull it straight out. Do not pull on the cable

because this may break the wires.

2. Insert the rubber plug into the antenna connector.

Note: Keep the rubber plug in the antenna connector when

not in use; this helps keep water out of the programmer.

9900213EN/197877_001/ccs 1/29/01 2:18 PM Page 71