Operation Information Guide
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install
in accordance with the manufacturer’s instruc-
tions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other appa-
ratus (including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polar-
ized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A
grounding type plug has two blades and a third
grounding prong. The wide blade or the third
prong are provided for your safety. If the pro-
vided plug does not t into your outlet, consult
an electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
11. Only use attachments/accessories specied by
the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or
table specied by the manufacturer,
or sold with the apparatus. When a
cart is used, use caution when mov-
ing the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms
or when unused for long periods of time.
14. Refer all servicing to qualied service person-
nel. Servicing is required when the apparatus
has been damaged in any way, such as pow-
er-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or
has been dropped.
15. Do not expose this apparatus to dripping or
splashing and that no objects lled with liq-
uids, such as vases, should not be placed on the
equipment.
Ne pas exposer cet appareil à des éclaboussures
ou gouttelettes d’un liquide. Aucun objet rem-
plie de liquide comme par exemple un vase ne
doit être placé sur l’appareil.
16. If this equipment is supplied with a power
supply cord only, the mains plug of the power
supply cord shall remain readily operable. To
completely disconnect this apparatus from the
a.c. mains disconnect the plug from the a.c.
receptacle.
Si l’équipement est uniquement alimenté par
un cordon d’alimentation, la che du cordon
d’alimentation doit demeurer aisément acces-
sible. Pour déconnecter complètement l’équi-
pement du réseau d’alimentation, déconnecter
la che du cordon d’alimentation de la prise
murale.
17. If this equipment is supplied with AC /DC
Adapter with separate power supply cord or the
AC/DC Adapter plugging directly into an a.c.
receptacle, they shall remain readily operable.
To completely disconnect this equipment from
the a.c. mains remove the AC /DC Adapter
mains power supply cord from the a.c. recep-
tacle or remove the AC /DC Adapter when it is
directly plugged into the a.c. receptacle.
Si l’équipement est alimenté par un adaptateur
AC/DC munis d’un cordon d’alimentation ou
un adaptateur AC/DC qui est alimenté directe-
ment à la prise murale, ils doivent demeurer
aisément accessibles. Pour déconnecter com-
plètement l’équipement du réseau d’alimen-
tation, déconnecter l’adaptateur AC/DC de la
prise murale ou déconnecter le cordon d’ali-
mentation de l’adaptateur AC/DC de la prise
murale.
18. WARNING: Do not expose batteries or battery
pack to excessive heat such as sunshine, re or
the like.
AVERTISSEMENT: Les batteries ou bloc de
batteries ne doivent pas etre exposees a une
chaleur excessive telle que celle du soleil, feu
ou autre source de chaleur similaire.
19. CAUTION: danger of explosion if battery is in-
correctly replaced. Replace only with the same
or equivalent type.
ATTENTION: danger d’explosion si la pile
n’est pas remplacée correctement. Ne remplac-
er que par le même type ou un type équivalent.
20. Connect mains power supply cord only to a
mains socket outlet with a protective earthing
connection.
21. Warning: The Ethernet connector of this
equipment must not be directly connected to
a public network. Connection is to be made
only by way of a modem or router approved
for this purpose.
The lightning ash with arrowhead, within an equilateral trian-
gle, is intended to alert the user to the presence of uninsulated
“dangerous voltage” within the product’s enclosure that may be
of sufcient magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intend-
ed to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompa-
nying the appliance.
ATTENTION:
RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING: TO REDUCE RISK OF
FIRE OR ELECTRICAL SHOCK, DO
NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE.
NO USER-SERVICEABLE PARTS INSIDE. RE-
FER SERVICING TO QUALIFIED PERSONNEL.
TO PREVENT THE RISK OF ELEC-
TRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SER-
VICEABLE PARTS INSIDE.
IMPORTANT SAFETY
INSTRUCTIONS!
PLEASE READ THEM BEFORE
OPERATING THIS EQUIPMENT.
a) User Information acc. to FCC15.21 as following:
Changes or modications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
b) Statement for Class B digital device acc. to FCC
15.105 as following:
NOTE: is equipment has been tested and found
to comply with the limits for a Class A/B
digital device, pursuant to part 15 of the
FCC Rules. ese limits are designed to
provide reasonable protection against harm-
ful interference in a residential installation.
is equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
o and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving
antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet
on a circuit dierent from that to which
the receiver is connected.
—Consult the dealer or an experienced
radio/ TV technician for help.
—is device complies with Industry
Canada licence-exempt RSS stan-
dard(s). Operation is subject to the fol-
lowing two conditions: (1) this device
may not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables
aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne
doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d’en compromettre le fonctionnement.
c) e device must be kept more than 20 cm from all
persons.
FCC INFORMATION (For US and Canada Customers
Additional Safety Information specic to this product may be
contained in the Owner’s Manual supplied with this product
Outdoor Antenna Grounding
If an outside antenna or cable system is connected
to the product, be sure the antenna or cable system
is grounded so as to provide some protection against
voltage surges and built-up static charge. Article 810 of
the National Electrical Code, ANSI/NFPA 70, provides
information with reguards to proper grounding of the
mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, and size of ground
conductors, location of antenna-discharge unit, con-
nection to ground electrodes and requirements for the
grounding electrode.
Example of antenna grounding as
per National Electrical Code,
ANSI/NFPA 70
2