Instruction Sheet

SUGGESTED CLEARANCE TO INSTALL COOKTOP

OVER A BUILT-IN OVEN

IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See cooktop Installation

Instructions for cutout dimensions. Center the cooktop cutout over oven cutout.

To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor,

delaminate or sustain other damage. This cooktop has been designed in accordance with UL and CSA International and complies with

the maximum allowable wood cabinet temperatures of 194°F (90°C).

The dimensions below are the suggested clearances to avoid physical interference between your cooktop and a built-in oven installed

below it.

NOTE: For undercounter installation, it is recommended that the junction boxes for the oven and cooktop be located in the adjacent right

or left cabinet. Check that a hole at least 1" (2.5 cm) minimum diameter was drilled in the left or right upper rear corner of the cutout side

wall. This hole allows the appliance cable to be passed through and connected with the junction box.

A. 36" (91.4 cm) from countertop to the floor

B. 4

⁵⁄₈

" (11.7) distance from floor to the oven cutout

C. 31

³⁄₈

" (79.7 cm) from bottom of oven cutout to top of counter

W10672375B

PAGE 1
SUGGESTED CLEARANCE TO INSTALL COOKTOP OVER A BUILT-IN OVEN IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See cooktop Installation Instructions for cutout dimensions. Center the cooktop cutout over oven cutout. To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage.
PAGE 2
ESPACEMENT SUGGÉRÉ POUR INSTALLER LA TABLE DE CUISSON SUR UN FOUR ENCASTRÉ IMPORTANT : Observer les dispositions de tous les codes et règlements en vigueur. La table de cuisson doit être homologuée pour une utilisation au-dessus d’un four. Pour éviter d’endommager les placards, consulter le constructeur de la maison ou le fabricant des placards pour déterminer si les matériaux utilisés peuvent subir un changement de couleur, une déstratification ou d'autres dommages.