Installation guide

ManualsBrandsMaytag Manualswall ovenOfficial Maytag 24" gas built-in oven

INSTALLATIONINSTRUCTIONS

24" (61.0 CM) GAS SINGLE

AND DOUBLEBUILT-INOVEN

Table of Contents

BUILT-IN OVENSAFETY ................................1

INSTALLATIONREQUIREMENTS .................3

Tools and Parts .............................................3

Location Requirements.................................3

Electrical Requirements................................4

Gas Supply Requirements............................5

INSTALLATION INSTRUCTIONS...................6

PrepareBuilt-In Oven....................................6

Make Gas Connection ..................................6

InstallOven....................................................7

Complete Installation....................................8

GAS CONVERSIONS.......................................9

LPGas Conversion .......................................9

NaturalGas Conversion..............................10

BUILT-INOVEN SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow

instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

iMPORTANT:

installer: Leave installation instructions with the homeowner.

Homeowner: Keep installation instructions for future reference.

W10203509A

Summary of content (12 pages)

PAGE 1
INSTALLATIONINSTRUCTIONS 24" (61.0 CM) GAS SINGLE AND DOUBLEBUILT-INOVEN Table of Contents BUILT-IN OVEN SAFETY ................................1 INSTALLATION REQUIREMENTS .................3 Tools and Parts .............................................3 Location Requirements.................................3 Electrical Requirements................................4 Gas Supply Requirements............................5 INSTALLATION INSTRUCTIONS ...................6 PrepareBuilt-In Oven.........................
PAGE 2
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. - Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. - WHAT TO DO IF YOU SMELL GAS: • • • • Do not try to light any appliance. Do not touch any electrical switch. Do not use any phone in your building. Immediately call your gas supplier from a neighbor's phone.
PAGE 3
INSTALLATIONREQUIREMENTS Product Dimensions - Single Oven Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed • Tape measure • Marker or pencil • Phillips screwdriver • • • Flat-blade screwdriver 1/8"Flat-blade screwdriver Pipe-joint compound resistant to LP gas • Level • Hand or electric drill • Wrench or pliers • • Pipe wrench 1%6" combination wrench • 1/8"(3.
PAGE 4
Product Dimensions - Double Oven Cabinet Side View - Double or Single Oven B E_ D _C A. 24" (61 cm) min. cutout depth B. 22%" (57.5 cm) recessed oven depth C. Oven front D. Recessed oven E. Cabinet A. 221/4'' (56.8 cm) max. recessed width B. 46%6" (117.6 cm) max. overall height C. 237/8'' (60.6 cm) overall width D. 22%" (57.5 cm) max. recessed depth E. 443/4'' (113.
PAGE 5
A120volt,60Hz.,AConly,15-amp fused,electrical circuitis required. Atime-delay fuseorcircuitbreaker isalso recommended. Itisrecommended thataseparate circuit serving onlythisovenbeprovided. Electronic ignition systems operate withinwidevoltage limits, butproper grounding andpolarity arenecessary. Check that theoutletprovides 120-volt powerandiscorrectly grounded. Thewiringdiagram islocated intheuppercontrol compartment ina clearplasticbag.
PAGE 6
For elevations above 2,000 ft (609.6 m), the burner should be reduced 4% for each 1,000 ft (304.8 m) above sea level (not applicable for Canada). Gas Pressure Regulator The gas pressure regulator supplied with this oven must be used. The inlet pressure to the regulator should be as follows for proper operation: Natural gas: Minimum pressure: 5" WCP Maximum pressure: 14" WCP LP gas: Minimum pressure: 11" WCP Maximum pressure: 14" WCP Contact local gas supplier if you are not sure about the inlet pressure.
PAGE 7
Use a 1%e" combination wrench and an adjustable wrench to attach the flexible connector to the adapters. Check that connector is not kinked. 3= Complete connection 1. Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. A. Closed valve B. Open valve 2= __ C _D....... A. Gas pressure regulator B. Use pipe-joint compound. C. Adapter (must have Y2"male pipe thread) D. Flexible connector 4.
PAGE 8
3. Securely fasten oven to cabinet using the 0.188 x 2.1" screws (4 for single oven, 6 for double oven) provided. Insert the screws through holes in decorative trim. To avoid cabinet damage, use the 0.140" diameter (number 28) drill bit to predrill the pilot holes before driving screws. Do not overtighten screws. i i _ 4. Replace oven racks. 5. Grasp sides of the door and align slots in door with the hinge arms. 6. Slightly pull the door open as you slide the door down onto the hinge arms.
PAGE 9
GAS CONVERSIONS Gas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer. To Convert Gas Pressure Regulator 1. Locate gas pressure regulator in bottom compartment. C G Explosion Hazard Use a new CSA International approved gas supply line. instal a shut=off valve. Securely tighten all gas connections. if connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.
PAGE 10
3. Flip the regulator pin over and snap pin firmly into place. Gcs Conveys on Turn manual shutoff valve to the closed position. Unplug oven or disconnect power. 1= 2. J A. Natural gas position B. LP gas position 4. Screw the hex-shaped Do not overtighten. 1. 2. To Convert Gas Pressure Regulator Burner Remove racks from inside the broiler cavity. Screw the burner orifice hood down tight against the pins. Do not overtighten. ...................... C A. Tooven B. Shutoff valve (closed position) C.
PAGE 11
2. Unscrew the hex-shaped regulator cap from the regulator and remove the regulator pin. 4. A Screw the hex-shaped regulator cap securely back into place. Do not overtighten. To Convert Oven Bake/Broil Burner 1. 2. Remove racks from inside the broiler cavity. Screw the burner orifice hood away from the pins. There will be approximately 11/2to 2 turns. A B A. Regu_rp_ B. Regu_rcap 3= Flip the regulator pin over and snap pin firmlyinto place. A. Burner orifice hood A A. LP gas position B.