Instructions / Assembly

IMPORTANT SAFETY INSTRUCTIONS FOR INDOOR USE ONLY
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed including the
following:
1) To reduce the risk of fire, do not deliberately reposition either bulb or lampholder contact.
2) To reduce the risk of overheating, replace burned out lamps promptly. This is an electrical product -
not a toy! To avoid the risk of fire, burns, personal injury, and electric shock it should not be played
with or placed where small children can reach it.
3) Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When
products are used in outdoor applications, connect the product to a Ground Fault Circuit interrupting
(GFCI) outlet. If one is not provided, contact a qualified electrician for proper installation.
4) This seasonal use product is not intended for permanent installation or use.
5) Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of
heat.
6) Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
7) Do not let lamps rest on the supply cord or on any wire.
8) Unplug the product when leaving the house, when retiring for the night, or if left unattended.
9) Do not use this product for other than its intended use.
10) Do not hang ornaments or other objects from cord, wire, or light string.
11) Do not close doors or windows on the product or extension cord as this may damage the wire
insulation.
12) Do not cover the product with a cloth, paper or any material not part of the product when in use.
13) The product employs overload protection (fuse). A blown fuse indicates an overload or short circuit
situation. If the fuse blows, unplug the product from the outlet. Also unplug any additional strings or
products that may be attached to the product. Replace the fuse as per the user servicing instructions
(follow product marking for proper fuse rating) and check the product. If the replacement fuse blows,
a short circuit may be present and the product should be discarded.
Read and follow all instructions that are on the product or provided with the product.
SAVE THESE INSTRUCTIONS
PRE-LIT TREE ASSEMBLY INSTRUCTIONS:
1. Follow the stand assembly instructions to set up
the tree stand.
a. Pull apart the legs of the stand so that they are
X-shaped.
b. Screw the eye bolts through the hole of metal
tabs. Turn screws so they touch tree trunk. Stand
tree up and straighten by adjusting screws in or
out then tighten screws.
2. Set section C to stand. Take all the hinged branches
to unfold into place. (See Fig. 1)
3. Shape the branches on the bottom section of your tree.
Note that some tree models have "side branches"
attached to the main branch stem that require
additional shaping.
4. Set the middle section B of tree into bottom section.
(See Fig. 2) Take all the branches to unfold into place.
Shape the tree to a full look. Connect plug B1 to end
plug C2.
5. Insert tree top A into the hole (pole cap) on the top of
the trunk of middle section.(See Fig.3) Take all the
branches to be shaped. Connect the
① ②
Eye Bolts
Fig 3
Fig 2
Eye Bolts
Fig 1
To Power Supply
A
B
C
A1
B2
B1
C2
C1