User Manual

INSTALLATION INSTRUCTIONS

Crescent Ice Maker Instruction Manual

WATER SUPPLY

1. Turn off the main water supply. Turn on the nearest faucet long enough to clear a line of water.

2. Find a 1/2" to 3/4" vertical cold water pipe near the installation location. The distance should be

less than 9 feet.

3. A shut-off valve must be installed to the main water supply. If the water pipe has a plain piece of

copper tubing, attach a 1/4" O.D. compression union to the tubing and remove the nut.

4. Thread the nuts of the supplied water supply hose to the tap and water inlet valve. Tighten rmly

by hand, then one-half turn with a wrench.

5. Turn on the main water supply and tap. Check for water supply connection leaks. Tighten all

connections.

LEVELING THE ICE MAKER

The ice maker must be leveled in order to work properly.

It can be raised or lowered by turning the four feet on the

bottom of the machine. We recommend using a

carpenter’s level to check the machine.

1. Place a carpenter’s level on top of the product to see

if the ice maker is level from front to back and side to

side.

2. Adjust the height of the feet as follows:

• Turn the leveling feet to the right to lower that

side of the ice maker.

• Turn the leveling feet to the left to raise that side of the ice maker.

DOOR REVERSAL

This appliance has the capability of the door opening from either the left or right side. The appliance

is delivered to you with the door opening from the left side. Should you desire to reverse the opening

direction, please follow the following reversal instructions.

Tools needed: Flathead screwdriver, Phillips screwdriver.

IMPORTANT: Before you begin, unplug the ice maker or disconnect power.