Datasheet

MAX535/MAX5351
Low-Power, 13-Bit Voltage-Output DACs
with Serial Interface
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS: MAX535
(V
DD
= +5V ±10%, REF = 2.5V, GND = 0V, R
L
= 5kΩ, C
L
= 100pF, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at
T
A
= +25°C. Output buffer connected in unity-gain configuration (Figure 8).)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
V
DD
to GND.................................................................-0.3V, +6V
REF, OUT, FB to GND................................-0.3V to (V
DD
+ 0.3V)
Digital Inputs to GND ...............................................-0.3V to +6V
Continuous Current into Any Pin.......................................±20mA
Continuous Power Dissipation (T
A
= +70°C)
Plastic DIP (derate 6.90mW/°C above +70°C).................552mW
µMAX (derate 4.00mW/°C above +70°C) ......................330mW
CERDIP (derate 8.00mW/°C above +70°C)...................640mW
Operating Temperature Ranges
MAX535_C_A/MAX5351_C_A...............................0°C to +70°C
MAX535_E_A/MAX5351_E_A ............................-40°C to +85°C
MAX535BMJA/MAX5351BMJA .......................-55°C to +125°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10sec).............................+300°C
Code dependent, minimum at code 1555 hex
4.5V ≤ V
DD
≤ 5.5V
MAX535MJA
CONDITIONS
kΩ14 20R
REF
Reference Input Resistance
V0V
DD
- 1.4V
REF
Reference Input Range
µV/VPSRRPower-Supply Rejection Ratio 600
±0.5
Bits13NResolution
ppm/°C1Gain-Error Tempco
LSBGEGain Error (Note 1) -0.5 ±6
ppm/°C6TCV
OS
Offset-Error Tempco
LSB±1.0INL
Integral Nonlinearity
(Note 1)
±2.0
±0.3 ±8 mVV
OS
Offset Error
UNITSMIN TYP MAXSYMBOLPARAMETER
MAX535A
MAX535B
Guaranteed monotonic LSB±1.0DNLDifferential Nonlinearity
V
REF
= 0.67Vp-p kHz650Reference -3dB Bandwidth
Input code = all 0s, V
REF
= 3.6Vp-p at 1kHz
V
REF
= 1Vp-p at 25kHz, code = full scale dB77SINAD
Signal-to-Noise Plus
Distortion Ratio
dB-84Reference Feedthrough
V2.4V
IH
Input High Voltage
V
IN
= 0V or V
DD
pF8C
IN
Input Capacitance
µA0.001 ±0.5I
IN
Input Leakage Current
V0.8V
IL
Input Low Voltage
STATIC PERFORMANCE—ANALOG SECTION
DIGITAL INPUTS
REFERENCE INPUT
MULTIPLYING-MODE PERFORMANCE