Datasheet

MAX4601/MAX4602/MAX4603
2.5 Ω , Quad, SPST,
CMOS Analog Switches
_______________________________________________________________________________________ 5
ELECTRICAL CHARACTERISTICS—Single +12V Supply (continued)
(V+ = 12V, V- = 0, V
L
= 5V, V
IN_H
= 2.4V, V
IN_L
= 0.8V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at
T
A
= +25°C.)
Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3: Guaranteed by design.
Note 4: ∆R
ON
= R
ON(MAX)
- R
ON(MIN)
.
Note 5: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal range.
Note 6: Leakage parameters are 100% tested at maximum-rated hot temperature and guaranteed by correlation at +25°C.
Note 7: Off-isolation = 20 log
10
[V
COM
/ (V
NC
or V
NO
)], V
COM
= output, V
NC
or V
NO
= input to off switch.
Note 8: Between any two switches.
Note 9: Leakage testing at single supply is guaranteed by testing with dual supplies.
Turn-On Time t
ON
160 nsFigure 2, V
COM_
= 10V, T
A
= +25°C
f = 1MHz, Figure 7, T
A
= +25°COn-Capacitance C
(COM)
140 pF
f = 1MHz, Figure 6, T
A
= +25°CCOM Off-Capacitance C
(COM)
85 pF
f = 1MHz, Figure 6, T
A
= +25°CNC_ or NO_ Capacitance C
(OFF)
85 pF
R
L
= 50Ω, C
L
= 5pF, f = 1MHz, Figure 5,
T
A
= +25°C
C
L
= 1.0nF, V
GEN
= 0, R
GEN
= 0, Figure 3,
T
A
= +25°C
Figure 2, V
COM_
= 10V, T
A
= +25°C
PARAMETER SYMBOL
MIN TYP MAX
(Note 2)
UNITS
Crosstalk (Note 8) V
CT
-60 dB
Charge Injection Q 20 pC
Turn-Off Time t
OFF
170 ns
CONDITIONS
SWITCH DYNAMIC CHARACTERISTICS