Datasheet

MAX4051/A, MAX4052/A, MAX4053/A
Low-Voltage, CMOS Analog
Multiplexers/Switches
8 _______________________________________________________________________________________
ELECTRICAL CHARACTERISTICS—Single +3V Supply (continued)
(V+ = +3.0V to +3.6V, V- = 0V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at T
A
= +25°C.)
T
A
= +25°C
C, E, M
CONDITIONS
ns90t
OPEN
Break-Before-Make Delay Figure 4
C, E, M
T
A
= +25°C
T
A
= +25°C
ns
ns
180 600
100 300
400
t
OFF
700
t
ON
Turn-On Time (Note 6) Figure 3
T
A
= +25°C dB<-90V
ISO
Off-Isolation
C
L
= 15pF, R
L
= 50Ω, f = 100kHz,
V
NO
= 1V
RMS
, Figure 6
T
A
= +25°C
Turn-Off Time (Note 6)
T
A
= +25°C dB<-90V
CT
Channel-to-Channel
Crosstalk
C
L
= 15pF, R
L
= 50Ω, f = 100kHz,
V
NO
= 1V
RMS
, Figure 6
Figure 3
UNITS
MIN TYP MAX
(Note 2)
SYMBOLPARAMETER
pC110QCharge Injection (Note 6)
C
L
= 1nF, R
S
= 0Ω, V
NO
= 0V,
Figure 5
Note 2: The algebraic convention is used in this data sheet; the most negative value is shown in the minimum column.
Note 3: ∆R
ON
= R
ON(MAX)
- R
ON(MIN)
.
Note 4: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal ranges; i.e., V
NO
= 3V to 0V and 0V to -3V.
Note 5: Leakage parameters are 100% tested at maximum-rated hot operating temperature, and guaranteed by correlation at
T
A
= +25°C.
Note 6: Guaranteed by design, not production tested.
DIGITAL I/OSWITCH DYNAMIC CHARACTERISTICS