F8249110V English / Espanol ñ / Francais ç www.parrotuncle.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Safety Information 1. To reduce the risk of electric shock, the electricity has been turned off at the circuit breaker or fuse box before begin. 2. All wiring must be in accordance with the National Electrical Code NASI/NFPA70-1999 and local electrical codes. Electrical installation should be performed by a qualified licensed electrician. 3.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Plastic wire nut (4PCS) Screws (2PCS) Mounting screws (2PCS) Washer (2PCS) Decorative Nut (25PCS) Blade screw (25PCS) Short Mounting Screws (3PCS) Mounting bracet Hanging Pin 4.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 1 Securely attach the hanger bracket to the outlet box using the screws and washers provided in the hardware bag. 2 Loosen the two coupling screws preassembled in the coupling , but do not remove them. Remove the locking pin and hanging pin from the downrod assembly. Retain for later use.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 4 Coupling screw 5 6 to 9 in Slide downrod into the coupling on top of the motor. Install the hanging pin by aligning the holes in the coupling with holes in the downrod. Secure hanging pin with locking pin. Securely tighten the two previously loosed set screws. Cut off excess lead wire approximately 6 to 9 inches above top of the downrod.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 6 BLACK (L) WHITE (N) Outlet box GREEN GREEN GREEN WHITE (AC IN N) BLACK (AC IN L) BLUE (FOR LIGHT L) BLUE (FOR LIGHT) WHITE (FOR LIGHT N) WHITE (FOR LIGHT) YELLOW (TO MOTOR) YELLOW (TO MOTOR U) GRAY (TO MOTOR) GRAY (TO MOTOR V) RED (TO MOTOR) Receiver RED (TO MOTOR M) Slide the receiver into the open Loosen the screws without fully removing
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 7 Securely attach and tighten the canopy cover over the screws in the mounting bracket utilizing the key slot twist-lock feature. Note: Adjust the canopy screws as necessary until the canopy and canopy cover are sung. 8 9 Make sure the blade is fully seated against the flywheel.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 10 11 12 Remove one of the three screws in the switch housing. Retain the screw for later and slightly loosen the remaining two screws. Connect the wires from motor to the wires from the light kit by using the 9-pin molex plug. Assemble the light kit to the switch housing by using the two key slots in the light kit.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER WIRING SCHEMATIC DIAGRAM FOR RECEIVER Light neutral-wire Light live-wire To Motor wire To Motor wire To Motor wire Black wire Power supply live-wire White Blue yellow Gray Red White wire Green Power supply neutral-wire Ground wire Antenna wire POWER PARAMETER LIST Voltage 120 V Fan (max.) 55W Lamp (max.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER SIZE OF PRODUCT 5.9" 2.3" 10.2" 2.5" 15.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER TROUBLE SHO OTING GUIDE 1.FAN / REMOTE IS NOT WORKING Ensure the remote is within the 20 foot range of the receiver To reset the remote control: 1) Turn off power to fan using the wall switch or circuit breaker. 2) Remove batteries from remote. 3) Wait 10 seconds.
F8249110V Installation & Operating Instructions for the Parrot Uncle Owner's Installation, Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AFTER INSTALLATION Wobble The fan blades have been adjusted in the factory to minimize any wobble Note: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the fan was mounted rigidly to the ceiling, It would cause excess vibration.