- CMF Smokey Mountain Series Gas Smoker Models 2505G 3405G 3405GW 3405BG 3005G 3405GT 3605G 3405BGW Assembly and Owner's Manual

Lighting Procedure

Igniter Lighting System:

Match Lighting:

1. Check all connections for leaks using the “soapy water”

test as explained on page 16.

2. Open the smoker cabinet door.

3. Check for any blockage to the venturi tube or burner.

Remove any foreign objects or matter.

4. Be sure the burner control knob is in the “OFF” position.

5. Open the LP cylinder valve by turning

counter-clockwise.

6. To light unit with the igniter, push in and turn the burner

control knob counter-clockwise to the high setting.

7. Immediately press or rotate the igniter repeatedly to

click it several times (you should see a small spark

jumping from the end of the electrode rod to the side of the

burner). If the burner doesn’t light within 3 to 5 seconds,

turn the burner control knob off and wait five minutes

before repeating the steps again. If burner still fails to light

try match lighting the smoker using the instructions noted

below.

8. Once the burner is lit, then close the door to allow heat

to accumulate. The dampers can then be adjusted to the

desired setting to allow proper air flow and combustion.

Damper adjustment tips are listed on the next page.

1. Repeat steps 1 thru 5 of the Igniter Lighting System

above.

2. Remove the Wood Chip Box and its stand from inside

the smoker. Light a paper match and drop it into the burn

chamber, making sure it falls next to the brass burner.

Quickly turn the control knob to the light position. If the

burner does not light within 4 or 5 seconds, turn the control

knob off, wait 5 minutes, and repeat the process.

1-1/2 turn