Manual

9. Dashboard setting up

• Connect the Marvelmind modem, as well as the autopilot telemetry modem to the

• To exclude mutual radio interference of equipment, you may try to use different

frequency bands, for example, 915 MHz for autopilot modems and 433 MHz for the

Marvelmind modem. In case it is not possible, try to use farther frequency channels

and separate antennas

• Launch "Dashboard" and "Mission Planner"

• Arrange the copter in its original state, from which it must take off

• Connect the battery to the Copter and wait for it to complete initialization

• Select the virtual Com port to which the autopilot telemetry modem is connected,

set the speed to 57600 baud and press "CONNECT"

• In "Mission Planner", the parameter "Yaw (deg)" should be between 356 and 5

degrees, but the closer to 0 is better

• In the "Dashboard" select the modem and in the right pane, in the properties you

need to specify the coordinates of the place where the copter will fly