Quick Start Guide

12 N
0
585 INTEGRATED AMPLIFIER / QUICK-START GUIDE
QUICK SETUP AND LISTEN
NOTE: For complete information about making
connections, see the
N
0
585 User Guide. at www.
marklevinson.com.
CAUTION: Before making connections, make sure the
N
0
585 and all associated components are powered off and
disconnected from electrical outlets.
1. Connect your speakers to the N
0
585's loudspeaker
binding posts. Connect the speaker's positive (+) terminal
to the N
0
585's positive (+) red binding post, and the
speaker's negative (–) terminal to the N
0
585's negative
(–) black binding post.
CAUTION: Be careful to not short the positive and negative
outputs together. Do not short the positive or negative
outputs to chassis or any other safety ground.
2. If your system includes a powered subwoofer, connect it
to the N
0
585's Line outputs. (Configure the Line outputs
as
Variable in the Setup menu. See the N
0
585 User Guide
for details.)
3. Connect up to four line-level analog source components
to the N
0
585's analog audio inputs. One set of balanced
(XLR) connectors and three sets of single-ended (RCA)
connectors are available.
4. Connect up to six digital source components to the
N
0
585's digital audio inputs. One AES/EBU (XLR)
connector, two coaxial S/PDIF (RCA) connectors, two
optical S/PDIF (TOSLINK) connectors and one USB-B
connector are available.
5. Connect the supplied power cable to the N
0
585's AC
Mains connector and into an electrical outlet. Power on
the N
0
585 and all associated components.
6. Press the Standby button on the N
0
585's front panel or
remote control to turn it on.
7. Rotate the N
0
585 select knob or press the Select
+/– buttons on the remote to select the N
0
585 input
that corresponds to an input connector to which you
connected a source component.
8. Make sure the N
0
585’s volume is set to a reasonable
level. Then, begin playing the selected source device.
NOTE: After connecting all source components to
the N
0
585, we suggest using the Setup menu to
set the names of all inputs that have no connected
source components to “Unused.” This will remove the
unconnected inputs from the list of available inputs
and they will be skipped when selecting the active
input. See the
N
0
585 User Guide for details.
INITIAL CONNECTIONS