Manual

8 N
0
585 INTEGRATED AMPLIFIER / OWNER’S MANUAL
The Advanced section of the Setup menu gives you access
to a range of configuration and administrative settings and
functions.
Firmware: This menu gives you access to the following
firmware-related functions:
Ver: Displays the version number of the currently loaded
firmware. (This setting is informational only, and does not
provide any user adjustments.)
Update: Lets you update your N
0
585’s firmware, either from
a flash drive inserted in the rear-panel USB port or from a
connected computer over the Ethernet connection. (If you
press Enter when ENET is selected, The N
0
585 ‘s display
shows “Start Download” to remind you to connect via a
browser and begin downloading the firmware.) To update via
a flash drive:
1. Select USB and press Enter.
2. The N
0
585 will read the USB drive. (The display will show
“Not Ready” while the drive is being read.)
3. When the N
0
585 finds a valid firmware file on the drive, the
display will show “Downloading.”
• If the N
0
585 does not find a valid firmware file on the
drive, the display will show “Not Available.”
Connect: This menu lets you select the type of control connection
you made to your N
0
585: Ethernet, or RS232.
Config: This menu lets you import or export Setup menu
configuration settings.
Export: Press Enter to export all setup configuration
information to a thumb drive inserted in the rear-panel USB
port. This data can then be used to identically configure
other N
0
585 units, or serve as a backup so you can easily
reconfigure your N
0
585.
Import: Press Enter to import all setup configuration
information from a thumb drive inserted in the rear-panel
USB port.
Lock: Engage the Lock to prevent accidental changing of
Setup menu parameters. The factory default setting is Off.
Restore: Lets you restore all N
0
585 parameters to their
factory-default condition.
Network: This menu offers access to the following network-
related parameters:
Name: N
0
585_XXXXXX: Displays your N
0
585’s network name
(the X’s represent the last six digits of the unit’s unique MAC
address). This setting is informational only and does not
provide any user adjustments.
DHCP: Lets you toggle DHCP mode (network auto-
configuration) on or off. The factory default behavior is
On. When the mode is set to Off, you can specifiy static IP
and Subnet addresses for your N
0
585. Selecting Renew
(available only when DHCP is set to On) refreshes your DHCP
configuration, assigning a new IP address to your N
0
585.
This function is often useful when troubleshooting a network
connection.
Current IP: Shows the IP address currently assigned (by DHCP
or manually) to your N
0
585. (This setting is informational only
and does not provide any user adjustments.)
Current Subnet: Shows the subnet address currently
assigned (by DHCP or manually) to your N
0
585. (This
setting is informational only and does not provide any user
adjustments.)
Trigger: This setting configures how the 12V trigger relay data
is sent and received. Most components require this to be set
at “Normal,” but some products (such as some older Mark
Levinson components) require that it be set to “Pulsed.”
Front IR: This menu allows you to turn the N
0
585’s front IR
receiver on or off. If you have connected the N
0
585’s rear-panel
IR input to an IR control device, we recommend that you set the
Front IR receiver to Off to avoid interference.
SETUP MENU
ADVANCED
Advanced
Firmware
Connect
Config
Network
Trigger
Front IR
Setup Menu
Input Setup
Power Mgmt
Volume Control
Advanced
Output