How to Guide

Install two D Cell batteries. Check the door of the battery compartment for correct

battery position.

- Open the hot water on a nearby faucet. Conrm proper water ow through the unit

and out of the faucet. (You should hear a "clicking" sound from the unit-this is the ignit-

or activating). Turn the water back o.

- Start the gas supply. Check again for gas leaks using soapy water and correct as neces-

sary.

- Open the hot water faucet. You should hear the ignition clicking, and hot water should

begin owing. Sometimes, if there is air in either the water or gas supply lines, you will

not get immediate combustion. If this is the case, turn the water on and o several

times to clear the water and gas lines of any air pockets that may be present.

- All water heaters have a seasonal summer/winter switch to meet your water tempera-

ture needs. This is because extra heating may be required when incoming water tem-

peratures are lower (winter), and less heating is required when incoming water tem-

peratures are higher (summer). Use the summer setting when incoming water tempera-

tures are a little higher. Use the winter setting when incoming water temperatures are a

little lower.

- When the water supply is turned o, the water heater will stop working. When you turn

the water back on, the water heater will reignite. Please note that if you use the hot

water multiple times in quick succession, the water may be excessively hot for one or

two seconds. Please wait for the temperature to adjust before using.

- If you close the water inlet valve or the water outlet valve, the water heater will shut o

immediately. Shut o the gas supply after use.

OPERATING INSTRUCTIONS

Specification

Sighting window

Winter/Summer knob

Gas controlling knob

Water controlling knob

(D). Water heater type D

(Drawing 1)

H D

Instruction