Installation Guide

ManualsBrandsMARAZZI ManualsCeramic Floor & Wall TileUrban Fusion Brickscape Jet 3 in. x 12 in. Ceramic Floor and Wall Tile (5.28 sq. ft. / case)

Developed by Nature Rapolano

12 in. x 12 in. tile shown in grid pattern

Installation of

FLOOR & LARGE

FORMAT TILE

INSTALLATION INSTRUCTIONS | FLOOR & LARGE FORMAT TILE | PAGE 1 of 4

• Tile may be

installed over most

structurally sound

substrates.

• Make sure surface

is clean, smooth,

dry and free of

wax, soap scum

and grease.

• Any damaged,

loose or uneven

areas must be

repaired, patched

and leveled.

• Remove any

moldings, trim,

appliances, or

anything that

could interfere with

installation.

• Doorjambs may be

undercut for tile to

slip under.

• Mark the center point of all

four walls.

• Snap chalk lines between

the center points of opposite

walls. (Adjust if necessary.)

• Using tile spacers, lay out

a row of loose tiles along

the center lines in both

directions. Leave space for

uniform joints.

TIP: If cuts leave tiles

smaller than half of their

original size, adjust the

center line by snapping a

new line a half tile closer to

the wall. Repeat along other

center line if necessary.

• Divide the room into smaller

grids (approx. 2 ft x 3 ft) by

snapping additional lines

parallel to center lines.

STEP 1: SURFACE PREPARATION

STEP 2: LAYOUT

CONTINUED ON NEXT PAGE

Summary of content (4 pages)

PAGE 1
Installation of FLOOR & LARGE FORMAT TILE 1 Developed by Nature Rapolano 12 in. x 12 in. tile shown in grid pattern STEP 1: SURFACE PREPARATION • T ile may be installed over most structurally sound substrates. • M ake sure surface is clean, smooth, dry and free of wax, soap scum and grease. • A ny damaged, loose or uneven areas must be repaired, patched and leveled. • R emove any moldings, trim, appliances, or anything that could interfere with installation.
PAGE 2
Installation of FLOOR & LARGE FORMAT TILE 3 Developed by Nature Rapolano 12 in. x 12 in. tile shown in grid pattern STEP 3: APPLYING ADHESIVE • M ix only enough adhesive or mortar to be used within 30 minutes. • U sing the type of trowel recommended on the adhesive package, spread a 1/4 in. coat on the surface of one grid area, using the flat side of the trowel. NOTE: Do not cover guidelines or a larger area than can be set in 15 minutes.
PAGE 3
Installation of FLOOR & LARGE FORMAT TILE 5 Developed by Nature Rapolano 12 in. x 12 in. tile shown in grid pattern STEP 5: SETTING TILE • I nstall tiles in the center, one grid at a time. Finish each grid before moving to the next. Start with the first tile in the corner of the grid and work outward. Set tiles one at a time using a slight twisting motion. NOTE: Don’t slide tiles into place. • I nsert tile spacers, as each tile is set, or leave equal joints between tiles.
PAGE 4
Installation of FLOOR & LARGE FORMAT TILE 7 Developed by Nature Rapolano 12 in. x 12 in. tile shown in grid pattern STEP 7: INITIAL CLEANING • T he complete removal of grout and construction dirt after products have been installed will improve daily maintenance. • C lean successfully by scrubbing the installation with hot water and a pH neutral liquid cleaner (soapless), followed by a thorough rinsing, then remove the rinse water with a wet vacuum or dry toweling.