Operation Manual

ManualsBrandsMarantz ManualsAmplifierPM8000

ENGLISH

FRANÇAIS

DEUTSCH

NEDERLANDS

ESPAÑOL

ITALIANO

PORTUGUÊS

SVENSKA

DANSK

OPERATION

TO PLAY AN ANALOG RECORD

1. Set INPUT SELECTOR to PHONO.

2. Play the record on the turntable.

3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-

just the tone.

NOTE:

• Be sure the set VOLUME to is minimum setting before placing

the stylus onto the record or before replacing the turntable’s car-

tridge.

• Never subject the turntable to shock or vibration while a record

is playing. This can cause the stylus to jump and possible

damage the record.

• Locating your turntable too close to the speakers can cause howl-

ing, which will make it impossible to use higher volume settings.

• Never turn off power while the stylus is in contact with the surface

of the record.

TO LISTEN TO AN FM/AM BROADCAST

1. Set INPUT SELECTOR to TUNER.

2. Tune in the desired station on the tuner.

3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-

just the tone.

TO PLAY A COMPACT DISK

1. Set INPUT SELECTOR to CD.

2. Play a CD on the CD player.

3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-

just the tone.

TO PLAY EQUIPMENT CONNECTED TO THE AUX 1 OR

AUX 2 JACKS

1. Set INPUT SELECTOR to AUX1 or AUX2.

2. Set up the connected equipment for play.

3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-

just the tone.

2 Perform the applicable operation on the connected

equipment.

(Illustration: PM8000)

@2 BASS AND TREBLE TONE CONTROLS

Use these controls to control the levels of their corresponding fre-

quency bands. TREBLE adjusts the high frequency band, while

BASS adjusts the low frequency band. Rotating a control towards

(+) enhance the frequency band, while rotating towards (–)

attenuates the frequency band.

@3 CLASS A SWITCH (PM8000 ONLY)

Press this switch while amplifier power is turned off to switch between

Class A (25W, 8 ohms) and Class AB (95W, 8 ohms) amplifier operation.

The CLASS A indicator is lit while CLASS A operation is selected, and

Class AB operation is indicated when the CLASS A indicator is not lit.

Remember that switching between CLASS A and Class AB is valid

only while amplifier power is turned off.

IMPORTANT:

The top cover may become hot during CLASS A operation, but this

does not indicate malfunction. Note, however, that you should never

place anything on top of this amplifier. Doing so can block ventilation

holes, resulting a build up of heat and malfunction of or damage to

the amplifier.

@4 SPEAKER SWITCHES 1/2

Use these switches to turn speaker output on (depressed) and off

(raised). You can turn off speaker output when listening to output

over headphones.

@5 PHONES JACK

Use the jack to plug in headphones that are equipped with a

standard phone jack.

@6 STANDBY INDICATOR

This indicator is lit while the amplifier is in the Standby Mode. Press-

ing the remote control unit’s POWER buttons switches the amplifier

between standby and power on.

INTEGRATED AMPLIFIER PM8000

INPUT SELECTOR VOLUME

POWER ON/OFF 1 2SPEAKERSSTANDBYPHONES

OFF

REC SELECTOR

TAPE PHONO CD

TUNER AUX1 AUX2

TAPE

CD-R/MD

CD-R/MDMUTE

BASS

SOURCE

SOURCE DIRECT

OFFONOFFON

CLASS A

OFFON

TREBLE BALANCE

MAXMIN

COPY

TAPE CD-R

CD-R TAPE