Mantis Reel Mower © 2006 Mantis, Div. of Schiller-Pfeiffer Inc. All Rights Reserved.
Table of Contents U S Please read these operating instructions before assembling and using your machine. Safety Instructions Maintenance Safety Decals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Assembly Views Mantis Reel Mower Views . . . . . . . . . . . . . . . . . . . .2 Assembly Instructions Maintenance/Care/Storage . . . . . . . . . . . . . . . . . . . .8 Disposal/Recycling . . . . . . . . . . . . . . . . . . . . . . . . .
Mantis Reel Mower View U S 2
Mantis Reel Mower Views U S 3
Mantis Reel Mower Views U S 4
Mantis Reel Mower Assembly Instructions U S A. Operating Parts (Fig. A – X) 1. Cutting cylinder (Fig. V) 15 Release knob (Fig. U) 2 Lower blade (Fig. V) 16 Starting handle (Fig. U) 3 Upper section of the guide handle (Fig. A) 17 Grass catcher (accessory) (Fig. X) 4 Middle section of the guide handle (Fig. A) 18 Grass catcher holders (Fig. X) 5 Lower section of the guide handle (Fig. A) 19 Hooks for grass catcher (Fig. X) 6 Wing nuts with bolts (Fig. A) 20 Battery (Fig.
D. Using your Mantis Reel Mower Correctly The Mantis Reel Mower is designed for cutting lawns in and around the garden. It is not designed for use in public Facilities, parks, sporting grounds, on roads, in agriculture or forestry. U S It is essential to observe the manufacturer’s operating instructions to ensure the unit’s proper functioning. The operating instructions also contain advice for service, maintenance and repair.
U S 3. Loosen both fixing nuts (9). 4. With both hands on the adjusting handles (12) set the cutting height you require (Fig. O): • Highest cutting height: 45 mm • Lowest cutting height: 20 mm NOTE: Make sure that the arrows marking the cutting height (8) show the same cutting height on both sides of the scale (Fig. O1). 5. Re-tighten both fixing nuts (9) (Fig. N).
G. Information Concerning Correct Mowing 1. General remarks on the care of lawns At the beginning of the grass cutting season and with newly laid lawns, we recommend you select a relatively high cutting height (e. g. 45 mm) then gradually decrease the cutting height over time. To maintain a well kept lawn you should set the cutting height to approximately 25-30 mm. If possible, mow your lawn once a week. When you mow your lawn frequently the short roots of the grass grow making your lawn more resistant.
U S 2. The battery (Fig. P) Cleaning Charging the battery After using the mower clean with a moist cloth. Spray the cutting cylinder and lower blade with an oil of low viscosity (e.g. spray oil). NOTE: Only charge the battery with the charger supplied! Using other charging units could lead to damage and injury. Using a charger other than the Mantis charger supplied releases Mantis from all liability and warranty claims.
I Disposal / Recycling These batteries contain nickel/cadmium cells. After their lifetime has expired, they may not be disposed of as normal house rubbish, but must be disposed of properly. U S Please return the battery to a Mantis dealer that sells the battery or take them to a recycling centre that accepts and recycles rechargeable batteries. J. Instructions for Correct Use / Safety Instructions 1. Checks Before Each Operation 3. Interruptions of Work Inspect the unit before each use.
U S K. Trouble-Shooting The following table contains the problems most frequently occurring and shows how to remedy them. Problem Possible Cause Remedy Abnormal noise. Clattering in the unit. Motor fixing screws or mower casing loose. Tighten screws. Metal-like hammering noises. Foreign body blocking the cutting cylinder. Turn off the mower. Pull the battery out of the contact bar. Remove the foreign body. Motor will not start. The battery is not pushed all the way in.
2 YEAR LIMITED SERVICE & WARRANTY POLICY FOR PRUNER ATTACHMENT MANTIS extends this limited warranty against defects in material and workmanship for a period of two years from the date of purchase, to the first retail purchaser and each subsequent owner during the warranty period. This warranty covers all portions of the Mantis Pruner Attachment.
