SDS

2
CONTINUED: SECTION 3. COMPOSITION, INFORMATION OR INGREDIENTS
Common chemical name I General name
CAS Number
Concentration
I Concentration R ange
Lithium Nickel Cobalt Manganese Oxides (active material) 182442-95-1
25~33%
Polyvinylidene Fluoride (binder)
24937-79-9
0.5~1%
Carbon black (conductive material)
1333-86-4
0.5~1%
Graphite(active material)
7782-42-5
13~17%
Styrene-butadiene rubber / Carboxymethyl cellulose sodium
salt (binder)
N/A
0.1~1%
Organic Solvent (non-aqueous liquid)
N/A
9~13%
Others
-
30~50%
SECTION 4. FIRST AID MEASURE
The product contains organic electrolyte. In case of electrolyte leakage form the battery, actions described below are required.
Eye Contact: Flush the eyes with plenty of clean water for at least 15 minutes immediately, without rubbing, and call a doctor. If
appropriate procedures are not taken; this may cause an eye irritation.
Skin Contact: Wash the contact areas off immediately with plenty of water and soap. If appropriate procedures are not taken,
this may cause sores on the skin.
Inhalation: Remove to fresh air immediately, and call a doctor.
SECTION 5. FIRE FIGHTING MEASURES
• Use specified extinguishers (gas, foam, powder) and extinguishing system under the Fire Defense Law.
• Since corrosive gas may be produced at the time of fire extinguishing, use an air inhalator when danger is predicted.
• Use a large amount of water as a supportive measure in order to get cooling effect if needed. (Indoor/outdoor fire hydrant)
• Carry away flammable materials immediately in case of fire.
• Move batteries to a safer place immediately in case of fire.
SECTION 6. ACCIDENTAL RELEASE MEASURES
• Wipe off with dry cloth
• Keep away from fire
• Wear safety goggles, safety gloves as needed
SECTION 7. HANDLING AND STORAGE
Storage: Store within the recommended limit of -30°C to 60°C (-22°F to 140°F), well-ventilated area. Do not expose to high
temperature (60°C/l40°F). Since short circuit can cause bum hazard or safety vent to open, do not store with metal jewelry,
metal covered tables, or metal belt.
Handling: Do not disassemble, alter, or solder. Do not short + and - terminals with metal.
Do not open the battery pack.
Charging: Charge within the limits of 0°C to 40°C (32°F to l04°F) temperature. Charge with specified charger designed for this
battery pack
Discharging: Discharge within the limits of -20°C to 60°C (-4 °F to 140°F) temperature.
Disposal: Dispose in accordance with applicable federal, state and local regulations.