Use and Care Manual

Table Of Contents

18 ENGLISH

When removing the wireless unit, open the lid slowly.

Thehooksonthebackofthelidwillliftthewirelessunit

as you pull up the lid.

►1. Wireless unit 2. Hook 3. Lid

Afterremovingthewirelessunit,keepitinthesupplied

case or a static-free container.

NOTICE: Always use the hooks on the back of

the lid when removing the wireless unit. If the

hooks do not catch the wireless unit, close the lid

completely and open it slowly again.

Tool registration for the vacuum

cleaner

NOTE:AMakitavacuumcleanersupportingthe

wireless activation function is required for the tool

registration.

NOTE: Finish installing the wireless unit to the tool

before starting the tool registration.

NOTE: During the tool registration, do not pull the

switch trigger or turn on the power switch on the

vacuum cleaner.

NOTE: Refer to the instruction manual of the vacuum

cleaner, too.

If you wish to activate the vacuum cleaner along with

theswitchoperationofthetool,nishthetoolregistra-

tion beforehand.

1. Install the batteries to the vacuum cleaner and the

tool.

2. Set the stand-by switch on the vacuum cleaner to

"AUTO".

►1. Stand-by switch

3. Press the wireless activation button on the vac-

uum cleaner for 3 seconds until the wireless activation

lampblinksingreen.Andthenpressthewirelessacti-

vation button on the tool in the same way.

1 2

►1. Wireless activation button 2. Wireless activation

lamp

If the vacuum cleaner and the tool are linked success-

fully, the wireless activation lamps will light up in green

for 2 seconds and start blinking in blue.