Use and Care Manual

21 ENGLISH

Cancelling tool registration for the

vacuum cleaner

Perform the following procedure when cancelling the

tool registration for the vacuum cleaner.

1. Install the batteries to the vacuum cleaner and the

tool.

2. Set the stand-by switch on the vacuum cleaner to

"AUTO".

►1. Stand-by switch

3. Press the wireless activation button on the vac-

uumcleanerfor6seconds.Thewirelessactivation

lampblinksingreenandthenbecomered.Afterthat,

press the wireless activation button on the tool in the

same way.

1 2

►1. Wireless activation button 2. Wireless activation

lamp

If the cancellation is performed successfully, the wire-

less activation lamps will light up in red for 2 seconds

and start blinking in blue.

NOTE:Thewirelessactivationlampsnishblinkingin

red after 20 seconds elapsed. Press the wireless acti-

vation button on the tool while the wireless activation

lamp on the cleaner is blinking. If the wireless acti-

vation lamp does not blink in red, push the wireless

activationbuttonbrieyandholditdownagain.