SDS

ManualsBrandsMakita ManualsTools & Hardware18-Volt LXT Brushless Lithium-Ion 1/2 in. Cordless Hammer Drill Kit

CONTINUED: SECTION 8. EXPOSURE CONTROLS AND PERSONAL PROTECTION

1-Methyl-2-

pyrrolidinone

Not applicable

TWA = 40 mg/m³,

TWA= 10 ppm,

STEL = 80 mg/m³,

STEL = 20 ppm

Aluminum Lithium

Oxide (LiAlO)

TWA = 1 mg/m³

(respirable particulate

matter)(Aluminum

CAS.no 7429-90-5)

Not available

TWA = 15 mg/m³

(Aluminum Metal

(as Al) Total dust)

TWA = 5 mg/m³

(Aluminum Metal

(as Al) Respirable

fraction) (Aluminum

CAS. No 7429-90-5)

TWA = 1 mg/m³

(Aluminum Metal

(as Al), Respirable

fraction)

(Aluminum CAS.

No 7429-90-5)

Not applicable

Chromium

TWA = 0.5 mg/m3

(inhalable particulate

matter); TLV basis:

respiratory tract

irritation,

TWA = 0.5 mg/m3

Not available

TWA = 0.5 mg/m3

(Chromium (II)

compounds (as

Cr),Chromium

(III) compounds

(as Cr))

TWA = 1 mg/m3

(Chromium metal

and insol. salts(as

Cr))

TWA = 0.5 mg/m3

(Chromium (II)

compounds (as

Cr),Chromium

(III) compounds

(as Cr))

TWA = 0.5 mg/m3

(Chromium metal

and insol. salts(as

Cr))

TWA = 2 mg/m3

Lithium Carbonate

Not applicable

Ethylbenzene

TWA = 20 ppm

Not available

TWA = 100 ppm

TWA = 435 mg/m3

TWA = 100 ppm

(ST) 125 ppm

TWA = 442

mg/m³

TWA = 100 ppm

STEL =884

mg/m³

STEL = 200 ppm

8.2 Exposure controls

8.2.1 Appropriate engineering controls :

Substance/mixture related measures to prevent exposure during identified uses:

- Avoid charging batteries in areas where hydrogen gas accumulate.

- Use local exhaust ventilation to maintain concentrations of hydrogen below the Lower Explosive collect and transport flammable

gases in ventilation systems.

- Insure proper ventilation is present and electrolyte mist and vapours.

Structural measures to prevent exposure:

- Avoid charging batteries in areas where hydrogen gas accumulate.

-Use local exhaust ventilation to maintain concentrations of hydrogen below the Lower Explosive collect and transport flammable

gases in ventilation systems.

-Insure proper ventilation is present and electrolyte mist and vapours.

Organizational measures to prevent exposure: Not available

Technical measures to prevent exposure:

-Insure proper ventilation is present and electrolyte mist and vapours.

8.2.2 Individual protection measures, such as personal protective equipment:

Eye and face protection

- Wear ANSI approved safety glasses with side shield during normal use.

- Wear NIOSH approved face shield with safety glasses and H.V protection during intentional disassembly.

Skin protection

Hand protection

- Wear nitrile butyl rubber, neoprene, or PVC glove during battery component disassembly.

- Discard contaminated work clothing after one work day.

Other skin protection

- Wear protective clothing during battery component disassembly.

- Discard contaminated work clothing after one work day.