TW0200 Impact Wrench Instruction Manual

Installing or removing socket

CAUTION:

• Always be sure that the tool is switched off and

unplugged before installing or removing the socket.

Align the hole in the side of the socket with the detent pin on

the anvil and push it onto the anvil of the tool until it locks into

place. Tap it lightly if required.

To remove the socket, simply pull it off.

Hook

The hook is convenient for temporarily hanging the tool. This

can be removed without using a tool.This can be installed on

either side of the tool.

Installing and removing hook

Expand the upper part of the hook in both directions and

remove it. To install the hook, follow the removal procedure

in reverse.

1. Socket

2. Anvil

003998

1. Hook

004000