Operation Manual

12
ENGLISH
Explanation of general view
1 Auxiliary plate
2Hex bolt
3 Base
4Nut
5Bolt
6 Lower blade guard A
7 Lower blade guard B
8 Top blade guard
9 Screw
10 Handle
11 Lever
12 Socket wrench
13 Adjusting bolt
14 Top surface of turn base
15 Periphery of blade
16 Guide fence
17 Pointer
18 Lock lever
19 Grip
20 Miter scale
21 Bevel scale
22 Switch
23 Lamp switch
24 Lamps
25 Stopper pin
26 Clamping screw
27 Top table
28 Motor housing
29 Center cover
30 Shaft lock
31 Saw blade
32 Blade case
33 Arrow
34 Outer flange
35 Inner flange
36 Spindle
37 Ring
38 Riving knife
39 Area to press in
40 Blade width
41 Rip fence holder
42 Guide rail on the top table
43 Clamping screw (A)
44 Clamping screw (B)
45 Rip fence
46 Rip fence holder
47 Workpiece
48 Line to be aligned with
49 Square nut
50 Scale
51 Two screws
52 Dust nozzle
53 Dust bag
54 Fastener
55 Cap
56 Vacuum cleaner
57 Blade cover
58 Support
59 Turn base
60 Vise arm
61 Vise rod
62 Holder
63 Holder assembly
64 Vise knob
65 Projection
66 Vise shaft
67 Rod 12
68 Vise (optional accessory)
69 Spacer block
70 Aluminum extrusion
71 Set plate
72 Small boss
73 Face/edge parallel
74 Wood screw
75 Glue together
76 Hole (7 mm in diameter)
77 Washer
78 Nut
79 Bolt M6
80 Push stick
81 Auxiliary fence
82 Push block
83 Triangular rule
84 0° adjusting bolt
85 Arm
86 45° bevel angle adjusting bolt
87 Limit mark
88 Screwdriver
89 Brush holder cap
SPECIFICATIONS
Model LH1040/LH1040F
Blade diameter .................................................................................................................................. 255 mm – 260 mm
Hole diameter
For all countries other than European countries .......................................................................... 25.4 mm and 25 mm
For European countries ......................................................................................................................................30 mm
Max. Cutting capacities (H x W) with blade 260 mm in diameter in the miter saw mode
Max. Cutting capacities at 90° in the table saw (bench saw mode) ...................................................................... 40 mm
No load speed (min
–1
) ............................................................................................................................................ 4,800
Table size (W x L)................................................................................................................................260 mm x 405 mm
Dimensions (L x W x H) ..................................................................................................... 530 mm x 476 mm x 535 mm
Net weight ............................................................................................................................................................13.7 kg
Safety class............................................................................................................................................................. /II
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Bevel angle
Miter angle
0° 45°
0°
69 mm x 130 mm
93 mm x 95 mm
right 69 mm x 85 mm, 93 mm x 67 mm
left 69 mm x 85 mm, 93 mm x 67 mm
45° (left)
35 mm x 130 mm
53 mm x 95 mm
right 35 mm x 91 mm, 49 mm x 67 mm
left 35 mm x 65 mm, 49 mm x 42 mm