Use and Care Manual

16
24
25
26
27
28
Begin the felling cut slighty higher than the felling notch
and on the opposite side of the tree (g. 22). Then cut
horizontally through towards the felling notch. Apply the
chain saw with its spikes directly behind the uncut portion
of wood and cut toward the notch (g. 23).
Leave approximately 1/10 of the tree diameter uncut!
This is the hinge (g. 23). Do not cut through the hinge
because you could lose control of the direction of the
fall. Drive wedges into the felling cut where necessary
to control the direction of the fall. Wedges should be of
wood, light alloy or plastic - never of steel, which can
cause kickback and damage to the chain.
Always keep to the side of the falling tree. When the
tree starts to fall, shut off the engine, withdraw the
bar and walk away on the pre-planned escape path.
Watch out for falling limbs.
WARNING!
Be extremely careful with partially fallen trees which
are poorly supported.
When the tree hangs or for some other reason does
not fall completely, set the saw aside and pull the tree
down with a cable winch, block and tackle or tractor.
If you try to cut it down with your saw, you may be
injured.
Sectioning Method
WARNING!
Felling a tree that has a diameter greater than the length
of the guide bar requires use of either the sectioning
or plunge-cut method. These methods are extremely
dangerous because they involve the use of the nose
of the guide bar and can result in kickback.
Only properly trained professionals should attempt
these techniques.
For the sectioning method (g. 24) make the rst cut with
the guide bar fanning in toward the hinge. Then, using the
bumper spike as a pivot, reposition the saw for the next
cut. Avoid repositioning the saw more than necessary.
When repositioning for the next cut, keep the guide bar
fully engaged in the kerf to keep the felling cut straight. If
the saw begins to pinch, insert a wedge to open the cut.
On the last cut, do not cut the hinge.
Plunge-Cut Method
Timber having a diameter more than twice the length of
the guide bar reauires the use of the plunge-cut method
before making the felling cut.
First, cut a large, wide notch. Make a plunge cut in the
center of the notch.
The plunge cut is made with the guide bar nose. Begin
the plunge cut by applying the lower portion of the guide
bar nose to the tree at an angle (g. 25). Cut until depth
of the kerf is about the same as the width of the guide
bar (g. 26). Next, align the saw in the direction in which
the recess is to be cut. With the saw at full throttle, insert
the guide bar in the trunk (g. 27).
Enlarge the plunge cut as shown in illustration (g. 28).