Instruction manual

[II] Disassembly/Assembly/Adjustment
1. Necessary Repairing Tools
2. Lubrication/Sealing
After you have disassembled the following parts, do lubrication or sealing as instructed below.
Needle bearing on clutch drum: Apply Makita grease N No. 2.
Spiral spring of recoil starter: Apply Makita grease N No. 2.
Engine: Apply Three bond 1215 to the contact surface between Crankcase and Cylinder.
Description Use forTool No.
Bearing Setting Tool 20-12.21R028
Retaining Ring Pliers ST-2N
Disassembling/assembling kickback brake
(inertia chain brake) system
1R003
Bearing Setting Plate 12.2 Press-fitting Bearing to Crankshaft1R034
Drill Chuck Remover 111R048
Copper Round Bar 20-100 Removing Flywheel1R091
Air Tightness Tester Testing Carburetor1R127
T-type Hex Wrench 3-127 Removing/installing M4 Hex socket head bolt1R170
T-type Hex Wrench 4-130 Removing/installing M5 Hex socket head bolt1R171
1/4" Hex Shank Bit for M5 Removing Engine1R229
Bearing Extractor Removing Bearing from Crankshaft1R269
13mm Hex Socket Bit
Removing/installing Clutch and Flywheel
Impact Driver (6990D, 6916D or the like)
Iron Hammer Removing Flywheel
0.3mm Thickness Gauge Fixing and adjusting Ignition coil complete
0.7mm Spark Plug Gauge Adjusting spark gap of Spark plug
2 / 20