Instruction manual
3.
Holders and holder assembly (optional accessories)
The holders and the holder assembly can be installed on either side as
a
convenient
means
of
supporting workpieces horizontally. Install them as shown in the figures
below. Then tighten the screws firmly to secure the holders and the holder assembly.
II
Screws
Holder assembly
I
Holder Holder assembly
When cutting long workpieces, use the holder-rod assembly (optional accessory). It
consists of two holder assemblies and two rods
12.
Holder assembly
//
CAUTl
ON
:
Always support long workpieces level with the top surface
of
the turn base
for
accurate
cuts and to prevent dangerous
loss
of
control of the tool.
18