Saw User Manual

MA1 NT ENANCE
CAUTION:
Always be sure that the tool
is switched off and unplugged before attempting to perform
inspection or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
to the limit mark. Keep the carbon brushes
clean and free to slip in
the holders. Both
carbon brushes should be replaced
at the
same time. Use only identical carbon
brushes.
Use
a screwdriver to remove the brush
holder caps. Take out
the worn carbon
brushes, insert the new ones and secure the
brush holder caps.
CAUTION
:
Never remove the breather
housing.
It is not an oil cap.
from the
gear
;Limit mark
L
Fig. 17
7Brush holder cap
I
Fig. 18
///
Fig. 1
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
12