Specifications

459mm
(18-1/16")
334mm 1
(13-1/8")
1.Holediameter8mm(5/16")
25mm(1"
1.6mm(1/4")Std.washer
2.No.10woodscrew40mm(1-1/2")
rain.length
Positioning table saw
Locate the table saw in a well lit and level area where
you can maintain good footing and balance. It should
be installed in an area that leaves enough room to easi-
ly handle the size of your workpieces. The table saw
should be secured with four screws or bolts to the work
bench or table saw stand using the holes provided in
the bottom of the table saw. When securing the table
saw on the work bench, make sure that there is an
opening in the top of the work bench the same size as
the opening in the bottom of the table saw so the saw-
dust can drop through.
If during operation there is any tendency for the table
saw to tip over, slide or move, the work bench or table
saw stand should be secured to the floor.
NOTE:Table saw stand
• Models 2702Xl and 2703Xl are standard-equipped
with a table saw stand.
1.6 mm (1/4") Std. washer
2.6 mm (1/4") Machine bolt & nut
tighten securely
\
1. Miter gauge
Storing accessories
The miter gauge and wrenches can be stored on the
left side of the base and the rip fence can be stored at
the rear of the base.
1. Rip fence