Installation Instructions

12
MSK-101-MM| Installation instructions v1.7 OCT 2018 |msk-101-mm_instructions_en_us v1.7|© 2017-2018 Inxpect SpA
Install and configure the
sensor
Assemble the sensor
1. Using the prepared holes, fasten the base to
the wall or to the junction box with two screws
(not provided). See "Perforated base
dimensions" on page21.
2. Extract the sensor from the adjustable
support.
3. Pass the cable with the wires coming out of
the alarm control unit into the sensor
housing.
4. Fasten the sensor housing to the base.
Assemble the sensor with the
MSK-101-BM adapter (sensor
directed to the right)
1. Using the prepared holes, direct the base of
the sensor as shown in the figure and fasten it
to the wall or to the junction box with two
screws (not provided). See "Perforated base
dimensions" on page21.
2. Assemble the adapter to the base, passing the
cable with the wires coming out of the alarm
control unit into the adapter.
Installation and use