Installation Instructions

Thank you for selecting our product. To ensure that your installation goes smoothly,
please read these instructions carefully and review the recommended materials and
tools before you begin.
Verify that your vanity top is free from defects. If damaged, please contact our
Customer Service department. Observe all local plumbing codes and building codes.
Questions? Call our Customer Service Department at 1-855-995-5578
or email [e-mail].
VANITY TOP & SIDE SPLASH
• INSTALLATION
• CARE AND MAINTENANCE
INSTALLATION (with integrated backsplash, gure 1)
1) Ensure the vanity base surface is at, level, and clean.
2)
Apply silicone caulk/sealant to all four corners of the vanity.
3) Place the top on the vanity base and assure it is aligned on all edges.
4) Leave for 3 hours to let the silicone set. If any warpage is obvious, put a weight
on top of a towel over the high points and leave over night for the top to settle.
Hand tighten all plumbing ttings; if necessary only ¼ turn with a wrench. Use
100% silicone instead of plumbers putty between all rubber gaskets and O-rings.
Silicone
Figure 1
Silicone
31” vanity top with wave
bowl shown in illustration
Figure 2
INSTALLATION (with separate backsplash, gure 2 and 3)
1) Ensure the vanity base surface is at, level and clean.
2)
Apply silicone caulk/sealant to all four corners of the vanity. Figure 2.
3) Place the vanity top on the vanity base and assure it is aligned on all edges.
Figure 2.
4) Put a small bead of silicone across the back side of the backsplash. Figure 2.
5) Place the backsplash centered on the vanity top with its back side pressed rmly
against the wall. Figure 3.
6) Run a small bead of silicone along the backsplash edges where it meets the wall
and vanity top and smooth the bead with a wet cloth or nger. Figure 3.
7) Leave for 3 hours to let the silicone set. If any warpage is obvious, put a weight
on top of a towel over the high points and leave over-night for the top to settle.
Hand-tighten all plumbing ttings; if necessary only 1/4 turn with a wrench. Use
100% silicone instead of plumbers putty between all rubber gaskets and O-rings.
Silicone
Silicone
Silicone
31” vanity top with wave
bowl shown in illustration
Figure 3
31” vanity top with wave
bowl shown in illustration
Note: Install the side splash AFTER installing the vanity top.
1) Ensure the vanity top surface is at, level and clean.
2) Put a small bead of silicone across the non-polished side
of the side splash. Note: For universal side splashes, add silicone to
the desired side.
3) Place the side splash on the vanity top with its non-polished
side pressed rmly against the wall and its back end pressed
rmly against the back splash.
4) Run a small bead of silicone along the side splash edges
where it meets the wall, vanity top and back splash and smooth
the bead with a wet cloth or nger.
5) Leave for 3 hours to let the silicone set.
SIDE SPLASH INSTALLATION (gure 4)