Use and Care Manual

Installation

Hardware List

Table top

Table leg

Decorative ring

8x16mm screws and washers

8x45mm screws and nuts

spare 4x15mm Self-tapping screws

Hexagonal screw tap

Place it as shown in figure 1, align the screw holes with 8x45mm screws

and nuts and fasten them.

PAGE 1
Installation Hardware List Hardware List 1 1 Table leg Table top 1 Decorative ring 8x16mm screws and washers 4 4 8 8x45mm screws and nuts spare 4x15mm Self-tapping screws 1 Hexagonal screw tap 1 Place it as shown in figure 1, align the screw holes with 8x45mm screws and nuts and fasten them.
PAGE 2
8x16mm screw and washer This is a spare screw hole. When the 8x16mm screw fails to be screwed in, the hole can be fixed with a 4x15mm self-tapping screw. Either way will do. Adjustable foot pads at the bottom of the support legs (when the ground is uneven, the foot pads can be used to adjust the balance) Put the table top on the table leg, make sure the reserved screw holes of the table top and the frame are corresponding, tighten 8x16mm screws from the bottom to finish the installation.