Owner`s manual

27
PUSH
21
3
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
Refer to the operating manuals of your balanced-output line-level
sources to verify that the pin assignments of their output connec-
tors correspond to the Nº32. If not, wire the cables so that the ap-
propriate output pin connects to the equivalent input pin.
To achieve the best possible results, we suggest using high quality
interconnecting cables such as Madrigal’s own CZ Gel-1 balanced
cables.
3 Single-ended Inputs 4-8
Accepts right-channel and left-channel (single-ended) inputs
from line-level source equipment such as tuners, CD players, and
tape decks.
To achieve the best possible results, we suggest using high quality
interconnecting cables such as Madrigal’s own CZ Gel-2 single-
ended cables.
4 Balanced Main Outputs
If your power amplifier is equipped with balanced (sometimes
called “differential”) inputs, it is generally best to use the balanced
outputs on your Nº32. A balanced signal from preamplifier to
power amplifier will offer the highest possible performance with
the best immunity from common-mode noise, such as radio fre-
quency interference (RFI). The balanced output signal is made
available by way of precision male XLR connectors (requiring fe-
male XLRs on the preamplifier end of the interconnecting cable).
The pin assignments of these XLR-type male outputs are:
12
3
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
Refer to your power amplifier’s operating manual to verify that
the pin assignments of its input connectors correspond to the
Nº32. If not, wire the cable so that the appropriate output pin
connects to the equivalent input pin.