Use and Care Manual
M-ROCK Stone
MAINTENANCE FOR ALL OUR STONE AND BRICK VENEERS
CLEANING
On occasion, washing to remove surface debris or dust may be required. For dirt, dust and other particle removal:
• Gentle scrubbing of the stones surface with a dry soft bristle brush is sufcient to remove dirt or other debris.
• If necessary use a solution of liquid dish detergent and water. Make sure the detergent does not contain any bleach or other
harsh chemicals. Gently scrub with soft bristle brush and detergent/water solution. Rinse well with clean water.
• If a stronger cleaning agent is necessary, try a granulated mild detergent mixed with water or mix a solution of (no more
than) one part white vinegar to ve parts water.
• Rinse with clean water to remove any solution that might remain on the surface.
• DO NOT attempt to clean M-ROCK Stone with acid cleaners, bleach, paint remover or any other type of concrete cleaner.
A pressure washer can be used if on low pressure so as to not damage the stone.
• DO NOT use wire brushes on M-ROCK Stone
EFFLORESCENCE
When eforescence occurs, as it does with many masonry products, it is usually the result of moisture migration through the masonry
substrate. Once the moisture is on the masonry surface, it evaporates, depositing dissolved salts in the form of eforescence.
Eforescence will disappear naturally over time as long as the source of the moisture is controlled or eliminated. If you wish to clean
off eforescence, use the following instructions:
• Eforescence may be removed with a solution of 1 part white, distilled vinegar to 6 parts water. Gently scrub using a soft
bristle brush and vinegar/ water solution. Rinse well with clean water.
SEALERS / PROTECTIVE TREATMENTS
Protecting M-ROCK Stone is not necessary, however, it is recommended in certain applications such as “at grade”, where
mud may splash onto the stone or on wood-burning replaces, which are exposed to smoke and soot.
• Penetrating stone sealers is recommended for most veneer stone and masonry sealing applications. This type of sealer pen-
etrates deep into the surface, sealing out water and contaminates. Penetrating stone sealers do not form a lm or change the
look of the surface. These are very effective, long lasting and offer easy maintenance. This sealant only needs maintenance
about every 5 years.
• A sealer, or protective treatment, will provide added protection and usually be easier to clean if the surface becomes dirty. If
you decide to seal your stone veneer, use only a silane or siloxane-based penetrating, breathable masonry sealer. Please
note that you should test a small area beforehand because a sealer may affect stone color
.
• It is always recommended that you test any sealer you intend to use on a small area to ensure compatibility.