Instructions / Assembly

The contents include:
■
2 panels
■
4 shelves
■
1 middle panel
Made in Taiwan • 2/2017
Inset A: Inset B: Inset C: Inset D:
Inset A: Inset B:
Top
Bottom
Right Side
Left Side
Inset A:
Inset A:
Inset B:
Widest
Flap
Shelf
Lay the 2 panels end-to-end on a flat surface, exactly like picture shows above.
Fold panel back and then fold tabs in-half where the score lines are indicated
(see Inset A & B). Insert tabs to connect panels together (see Inset C). Then
press the tabs flat (see Inset D).
Lay the organizer on the floor with the
open side up. Make sure all flaps inside
the organizer are flat. Position all outer
flaps so they are on the outside, away
from the center.
Raise both panels up towards each
other. Fold the tabs in-half and insert
into the panel to lock (see Inset A & B).
Then press the tabs flat.
To secure back of organizer, fold
top flap. Then fold left side flap,
then right side flap. Push
bottom flap inside the shelf
to complete.
Fold each shelf in half (total 4) along the score
line (see Inset A). Place the four shelves
inside (as shown), with the slit facing up.
Important: Make sure the widest flap is on
your right-hand side.
Slide the middle panel down, matching up center divider
slits. Important: Make sure the widest section on the
MIDDLE PANEL is on your right-hand side (see Inset A).
Fold and lock the two end flaps on both sides (see Inset B).
Then fold and lock all ten flaps to secure the shelves.
The completed organizer should look
as shown with the widest section
second from the right.