Installation Guide

ManualsBrandsLulani ManualsBathBora Bora Single Handle Single Hole Bathroom Faucet with Deckplate Included and Drain Kit Included in Brushed Nickel

Table Of Contents

1. Faucet

2. Above sink hardware: rubber O-ring

3. Below sink hardware: rubber washer,

metal washer, screw, lock nut

4. Water supply lines

5. Escutcheon (4” Baseplate)

6. Over-ﬂow pop-up drain

Installation Instructions

KA-310-01

Single Handle Bathroom Faucet

Thank you for selecting Lulani.

To ensure that your installation proceeds smoothly, please read

these instructions carefully before you begin.

Bora Bora

Recommended Tools (not included)

1. Adjustable Wrench

2. Phillips Screwdriver

3. Safety Goggles

4. Flashlight

5. Bucket

6. Measuring Tape

7. Plumber’s Putty

8. Channel Locks

9. Allen Key

Parts Included

Note: This faucet

has been packaged

with an over-ﬂow

pop-up drain. DO NOT

use with a non-over-ﬂow

sink.

Fa u c e t C o

Summary of content (4 pages)

PAGE 1
Fa u c e t C o Installation Instructions Bora Bora KA-310-01 Single Handle Bathroom Faucet Thank you for selecting Lulani. To ensure that your installation proceeds smoothly, please read these instructions carefully before you begin. Parts Included 1. Faucet 2. Above sink hardware: rubber O-ring 3. Below sink hardware: rubber washer, metal washer, screw, lock nut 4. Water supply lines 5. Escutcheon (4” Baseplate) 6.
PAGE 2
Caution: Tips for removal of old faucet Always turn off the water supply before removing the existing faucet or replacing any part of the faucet. Open the faucet handle to relieve water pressure and ensure that water is completely shut off. Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the ﬁnish and void your warranty.
PAGE 3
Step 3 Connect the water supply lines to the water valves. Tighten each end with an adjustable wrench. Do not over tighten! Double check all connections (shown with arrows in the image) for leaks. Re-tighten if necessary. Step 4 2 From the top of the drain hole, place the drain (1) through the installation hole. Make sure that the rubber o-ring (2) is on the top side of the sink. From under the drain hole, install the rubber gasket (3) and metal nut (4) by hand twisting on to the tail pipe of the drain.
PAGE 4
Step 5 Remove the aerator with an aerator wrench (a quarter or ﬂat surface tool will also work). Turn the faucet handle all the way on, turn on the hot and cold water supply and ﬂush water lines for one minute. Re-install the aerator with an aerator wrench. About our products The Bora Bora Single Handle Bathroom Faucet is striking yet sophisticated.