User manual

DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
468Access Endpoint
17
Extension
A display-only field showing the extension number as specified in the command
line, or shows the next available extension number if
next was entered on the
command line. This is the extension number assigned to the nonsignaling trunk
and used to access the trunk endpoint.
(Starting) Port
Enter seven characters.
For example, 01A0612 is in cabinet 01, carrier A, slot 06, and circuit number
(port) 12.
NOTE:
For Wideband Access Endpoints, analog tie trunks cannot be used and the
DS1 Interface circuit pack, Version C or later, must be used.
The DS1 circuit number corresponds to the channel that will carry the data traffic.
Channels 1 through 31 (DS1 Interface only) or channels 1 through 24 (DS1 Tie
Trunk, DS1 Interface, or DS1 Interface (32) circuit packs) may be used when the
DS1 Signaling Type field is
robbed-bit or isdn-ext. For Common Channel or
ISDN-PRI signaling, channel use is limited to channels 1 through 30 (DS1
Interface circuit pack only) or channels 1 through 23 (DS1 Interface (32) or DS1
Interface ). A channel can be administered as an access endpoint regardless of the
DS1 signaling type.
Valid entries Usage
01
through 44 (G3r) or
01 through 03 (G3si)
First and second characters are the cabinet number
A through E Third character is the carrier
01 through 20 Fourth and fifth character are the slot number
01 through 04
(Analog TIE trunks)
01 through 31
(DS1 Interface ports)
Six and seventh characters are the circuit number