LOSB0232
Safety Precautions This is a sophisticated radio controlled model that must be operated with caution and common sense. Failure to operate your Micro-Baja in a safe and responsible manner could result in damage to the model and property. The Micro-Baja is not intended for use by children without direct adult supervision.
chassis. 5) Remove the left side of the gearbox by removing the three screws. 6) Follow Figure 1 below to rebuild the differential (Use LOSA3066 Grease). 7) Once the differential has been rebuilt, assemble the transmission by following the steps in the reverse order. Be sure to use the screws in the same location that they were removed. When adjusted properly, you should be able to hold the rear tires firmly and barely be able to push the spur gear forward with your thumb.
Replacing the Steering Servo 1. Unplug all wires, remove receiver crystal and 4 screws pictured in Figure 1. (Be sure to note the locations of all screws and sizes.) 2. Remove the 2 screws pictured in Figure 2. and place the PC board to the side. 3. Remove the 4 screws pictured in Figure 3. Remove the servo cover. 4. Slide the servo out from the chassis as shown in Figure 4. 5. Replace with new servo and be sure to place the tip of the servo saver into the slot of the steering bellcrank. 6.
Safety Precautions: This is a sophisticated hobby Product and not a toy. It must be operated with caution and common sense and requires some basic mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage to the Product or other property. This Product is not intended for use by children without direct adult supervision. The Product manual contains instructions for safety, operation and maintenance.
