Quick Start Instruction Manual

ManualsBrandsLosi ManualsToysLOSB0202T3

Mini-DT Quick Start Guide―Page 1

Getting Started

NOTE:

Getting Started

Step 1

Step 3

Step 4

Step 2

Before you start running your new Mini-DT, it is absolutely necessary that you read

through all of the operating instructions to prevent unnecessary damage and get the

maximum enjoyment from your vehicle.

Plug the AC charger into the proper wall receptacle (110V).

Plug the battery pack into the charger and let it charge for

3 hours for the rst time. After running, or when the Mini-DT

slows noticeably, recharge the battery pack for 5-6 hours for

a full charge.

Remove the transmitter battery cover by sliding the cover

from left to right. Install eight (8) AA batteries into the

battery holder. Pay close attention to the correct direction

of the positive (+) and negative (-) ends as marked in the

tray. Once all 8 batteries have been installed, reinstall the

battery cover by sliding it on from right to left.

Insert the antenna wire through the antenna mount and

into the antenna tube (g. 1) pushing it through until it

comes out the other end. Push the antenna tube (g. 2)

into the antenna mount.

Once the battery

is charged,

remove the

body clip from

the front of the

battery tray (g.

3) and lift up the

front of the tray

(g. 4). Install

the battery pack

as shown (g.

5), reinstall the

body clip and

plug the battery

pack into the

ESC.

Fig 1

Fig 2

Fig 3

Fig 4

Fig 5

Summary of content (4 pages)

PAGE 1
Getting Started NOTE: Before you start running your new Mini-DT, it is absolutely necessary that you read through all of the operating instructions to prevent unnecessary damage and get the maximum enjoyment from your vehicle. Step 1 Step 2 Plug the AC charger into the proper wall receptacle (110V). Plug the battery pack into the charger and let it charge for 3 hours for the first time. After running, or when the Mini-DT slows noticeably, recharge the battery pack for 5-6 hours for a full charge.
PAGE 2
Step 5 Step 6 Off/On Always turn on the transmitter first by sliding the switch on the left side of the wheel from left to right. The small red and green lights above the switch should both light up. If not, check for low or incorrectly installed batteries. Step 7 The On/Off switch for the receiver/ESC is located on the right side toward the back of the unit. Locate the switch and slide the switch lever back to the “ON” position, which is clearly marked on the side of the switch.
PAGE 3
Mini-DT Troubleshooting Guide Doesn’t operate Battery not charged or plugged in Receiver switch not “on” Transmitter not ‘on” or low battery Charge battery / plug-in Turn on receiver switch Turn on / replace batteries Motor runs but rear wheels don’t move Pinion not meshing with spur gear Pinion spinning on motor shaft Slipper too loose Transmission gears stripped Drive pin in axle missing Adjust pinion/spur mesh Replace pinion gear on motor Check & adjust slipper Replace transmission gears Check & rep
PAGE 4
If you as the Purchaser or user are not prepared to accept the liability associated with the use of this Product, you are advised to return this Product immediately in new and unused condition to the place of purchase. Law: These Terms are governed by Illinois law (without regard to conflict of law principals). Inspection or Repairs If this Product needs to be inspected or repaired, please call for a Return Merchandise Authorization (RMA). Pack the Product securely using a shipping carton.