Installation & Assembly

Assembly Instructions for Single Pedestal Table
Tools Needed: 1/2” Wrench/Socket, Phillips or Square Screw Driver
Before beginning assembly, please take a few moments to carefully read the instructions, familiarize yourself
with the components and understand each step of the process. Likewise, please ensure that the hardware
package contains the items as described below.
Parts List: (1) Table Top Assembly, (1) Pedestal Post Assembly, (4) Wooden Legs, (4) Top Braces
Hardware List: (16) 5/16” Nuts, (16) 5/16” Washers, (8) Phillips/Square Drive Screws, (4) Leg Levelers
Assembly Instructions:
Step 1.
Remove components from shipping boxes. You may lay the cardboard on the floor to prevent marring of
finish.
Step 2. Place pedestal post upright on floor. (hole locations are the same; either end up works fine!)
Step 3. Attach 4 wooden legs to the post using the 5/16” washers and nuts.
Step 4. Screw leg levelers into each leg. Ensure they are completely seated.
Step 5. Carefully turn pedestal post over so that the post is upright with legs resting on floor.
Step 6. Attach the four top braces to the pedestal post using 5/16” washers and nuts, ensuring the braces are as
flush with the top of the post as possible.
Step 7. Gently place the table top face down on a clean, non-marring surface being careful not to scratch or dent
it.
Step 8. Turn pedestal post over, carefully placing it on the table.
Step 9. Center the pedestal post on the 1” x 6” cross member attached to the table top.
Step 10. Using the 3” screws, secure the top braces to the cross member, making certain that the braces are lush
against the table cross member.
Step 11. With the assistance of another person, turn the table over. Adjust the four leg levelers until satisfied.
PLEASE NOTE: If you purchased your item “ready to finish” special care must be taken to properly apply a
high grade final finish in a timely manner. Doing so will help protect your purchase from discoloration and
damage caused by exposure to ultra-violet light and/or weather. if the products intended use is outside,
please use an exterior rated finish to also protect from weather damage. See use and care instructions for
further information. Failure to adequately protect item by application and as needed, re-application of a final
finish may void warranty.