Assembly Instruction

ASSEMBLING &
INSTALLATION INSTRUCTIONS PRODUCT
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
Fig.2
Fig.3
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
(Ground)
Canopy
Clamp
Bolt
Hex
Coupling
ASSEMBLING THE FIXTURE (Fig.2).
1. Attach the glass shade(F) and collar ring(E) onto the lamp
holder, lock them securely with the check ring(D).
2. While holding the cover(A) and fixture body(C) , hooked by
the hook at both of the pipe(B).
3. Raise the top loop of cover(A) to the ceiling loop , connect
them with hanging chain.
4. Raise the fixture body(I) to the fixture body(C), hooked by the
hook at both of the pipe(G).
5. Attach the power plug(H) insert the socket.
6. Install the light bulbs in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE
SPECIFIED WATTAGE!
HANGING THE FIXTURE (Fig.1 Please see the Page.2)
IMPORTANT: For a safe and secure installation, this fixture
must be installed by means of support that is independent of
the junction box.
1. Shut off the power at the circuit breaker and remove old
fixture from ceiling, including the old crossbar.
2. Provide a 1/4” IPS pipe screw with one end securely mounted
to a beam or a structural member. The other end should
protrude through the center of the junction box as shown. The
junction box is not included.
3. Assemble the hex nuts, lock washer, hex coupling, pipe screw
and ceiling loop(product shall prevail) to center 1/4”IPS
support pipe and adjust overall length to allow the lock ring to
hold the canopy flush to the ceiling. When the adjustments
have been completed, secure the three (3) hex nuts, as shown.
4. Attach the chain to the fixture loop. Slip the lock ring and
canopy over the upper end of the chain. Open the open link of
the chain and lift the fixture to attach to the ceiling loop and
close the open link.
5. Lace the fixture wires, ground wire and safety cable through
the chain and loop, exiting through the side of the hex
coupling.
6. IMPORTANT: you must, run the safety cable through the
two clamp bolts, then through the top of the junction box
and secure to structural member. NOW, fasten the end of
safety cable through the two clamp bolts (see fig.1), lock
them securely with the four small hex nuts until tight.
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the
smooth wire leg from the fixture and twist bare ends together.
Twist wire connector onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed
wire leg of fixture wire. NOTE: Twist wires together in the
same direction you twist the wire connector onto wires.
3. If your junction box has grounding wire (green or bare
copper), attach this wire and the bare copper wire from the
fixture together as step 1.
4. Tuck these wire connections neatly into the ceiling junction
box and then raise the canopy all the way to the ceiling. Raise
the lock ring to the bottom of canopy, screw it with until tight.
Your installation is now complete. Return power to the
junction box and test the fixture.
Page 1 of 2