User's Guide

PAIRING THE WIRELESS WEATHER SENSOR WITH THE DISPLAY CONSOLE

SET THE LCD DISPLAY VIEWING ANGLE

CHANGING BATTERIES AND MANUAL PAIRING

Whenever you change the batteries in the sensor, you will need to manually repair it with the display

console. Follow these instructions to manually pair your console with the sensor.

1. Once your display console powers on, it should automatically search for and connect to the

wireless weather sensor. If the console does not connect within the rst 15 minutes, refer to the

following section, Changing Batteries and Manual Pairing, for instructions on manual pairing.

2. You will see the icon of an antenna blinking in the temperature and humidity (outdoor) section of

the display.

3. Once the pairing process completes, the antenna icon will appear solid (not blinking), and the

readings for outdoor temperature and humidity, wind speed, wind direction, and rainfall will

appear in their designated sections of the LCD display.

If you have the display console wall-mounted or on a table stand, the viewing angle may need

adjustment. Press or buttons while the display is in normal operating mode to adjust the

viewing angle.

NOTE: If nothing appears on the LCD display screen after you plug in the power adaptor, use a pin or

similar small object to press the RESET button.

1. Change the batteries in the wireless weather sensor.

2. Press the SENSOR/WI-FI button at the back of the console.

3. Press the RESET key on the underside of the wireless weather sensor. Make sure after pressing

the RESET key that the red LED indicator is ashing every 12 seconds.

WI-FI

SENSOR

RESET

REFRESH

MAX/MINHISTORYCHANNEL

BARO

UNIT

1 2