Installation Instructions

Tools Typically Required:
Tissue paper
Safety Precautions:
Well-ventilated area, gloves
Preparation:
Surfaces must be clean, dry and free from oil, wax and paint. Protect work area. Lightly roughen smooth surfaces for better
adhesion. Pre-fit parts to be joined.
Application:
Twist the cap counter clockwise from the nozzle and pull off. Apply the adhesive sparingly to one surface only using approximately
one drop per square inch of surface. Press surfaces together immediately. Hold in place for 5 to 30 seconds until bond sets. Do not
reposition parts. Clean tip of tube immediately after use with tissue and replace the cap by twisting clockwise. Leave parts
undisturbed for at least 10 minutes for increased strength. For full bond strength, leave parts to cure for 24 hours.
Clean-up
After cleaning, wet any tissue used for wiping off glue with water and dispose of. When cleaning up larger quantities of uncured
adhesive, apply water and allow to cure and then scrape up. Note this may result in damage to the surfaces. Cured adhesive may
be cut away with caution using a sharp blade, removed with acetone or with boiling water. Note: Acetone is highly flammable and
may not be suitable for use on all materials, test surface first. Follow manufacturer’s instructions.